Simplicity 1693407 Dokumentacja Strona 114

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 126
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 113
Analytical Modules, continued
Replacement Thermistor
Wiring Harness
Step Procedure
1. Making note of the connection location for each wire, remove
the wiring that is connected to the Thermistor/Filament Board
that is to be removed. Remove the wires by carefully pulling on
the end of the metal connector.
2. Remove the wiring harness by removing the 2 mm button head
hex screws that secure the 9-pin connector to the manifold.
3. Install the new wiring harness using the 2 mm button head hex
screws.
4. Reconnect wiring to the thermistor boards. Wiring MUST be
connected to the same cells as before. Verify all termination
points.
Note: The length of the wiring is such that color coded wires can
connect only to their specified bead. Also note that there are
two wires of each color. Technically, for a specific cell it does
not matter which wire is connected to which lead as long as the
color is correct. However, the wires should be connected as
shown in figure 4-11.
A5E31405710001 4-35
Przeglądanie stron 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 125 126

Komentarze do niniejszej Instrukcji

Brak uwag